Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 182)

Publication 1758-UM002D-EN-P - October 2010
182 DataSite Flow Configuration Utility (DS FloConfig)
5. To save the forced values, click No.
If you click Yes, the forced values will be discarded and calculation with
forced values will be disabled.
For example, after entering the values shown in step 1 for meter run 0,
the Meter Run0 window will display the forced values and calculate the
flow rate based on these values. You need to select the Meter Run and
Accumulate check boxes, and configure all the parameters required for
gas flow calculation, such as the gas component parameters.
The forced values should be as close as possible to the average value of
the field signals. The system will calculate flow rate based on these
forced values.