Yaskawa J50M Instructions - Manual (Page 154)

4.3.6 DISPLAY IN THE (SETTING)
FUNCTION
4.3.6.1 D I S P L A Y I N G A N D W R I T I N G S E T T I N G
D A T A
In this system, various setting data are held in the
internal memory and permit to
mirror image
axes, TV check on/off, etc. For details, see Appendix
1, “LIST OF NUMBERS”.
It is possible to display and write setting data at any
even during automatic operation.
1. Types of setting
Setting is made in binary mode or decimal
mode.
A. Binary mode
Setting numbers #6000 -#6004 are associated
with setting data of binary mode, that is,
2.
8-bit information (D7-DO) . Each bit in-
dicates the on state the associated
function. The decimal value of each line
is given at the rightmost column.
a setting number and then depress the
key. (“#” need not be en-
tered.) Up to 10 groups of setting number and
data will be displayed at a time.
Depress the CURSOR keys to change a set-
ting number and the PAGE keys to change
a screen,
3. Writing setting data
A.
(1)
(2)
( 3 )
DECIMAL VALUE
Fig. 4.24 Setting (Decimal model) -Example
(4)
B. Decimal mode
Setting numbers of #6200 -#6219 and #6500 -
#6599 are associated with setting data of
decimal mode.
( 5 )
In binary mode
Designate a desired setting number.
Depress the key. The cursor
moves to the bit data from a setting num-
ber.
Designate the data of D7.
the
SOR
key. Each time
the key is depressed, the cursor moves
one bit toward DO. Locate the at a
desired bit position.
Depress the WR key : The designated bit data
reverses (O to 1 or 1 to O). If the WR key is
depressed again, the bit data will reverse
again. Normally, “ 1” designates on state and
“O” off state.
To write data in decimal mode, locate the
at the rightmost column ( decimal
data) .
146