Yaskawa J50M Instructions - Manual (Page 225)

D2 1: Needs power off at occurrence of an alarm
related to reference point return.
o:
Does not need power off at occurrence of an
alarm related to reference point return.
1: Outputs FMF signal twice in can-
ned cycle.
O: Outputs the FMF once in can-
ned cycle.
Do Outputs the external operation signal
EF at the end of positioning by G81
being external operation function)
o: Does not output the external operation
signal EF at the end of positioning by
G81
being canned cycle)
1“’1”’1
l“’1“’1”’
D7
D6
D4
D3
Stops the tape at the initial “ %“ during tape
operation.
1: Effective
O: Ineffective
1: When parameter outputs, only #7000 to #7999
is output.
o: When parameter outputs, full range is
output.
1: Employs the feedrate set in parameter
#6232 for the skip function command
O: Employs the F code command as the
feedrate for the skip function command
1: Reset OFF at Emergency Stop
O: Reset ON at Stop
Specifies the tool shift direction in the canned
cycles of G76 and G77 (effective when
DO= O).
D2 Shift direction
1 0
o 1 -x
o 0 +x
1: Allows the tool shift direction in the
cycles
specified in setting #6506
in the +X direction in increments of
0.001; shift
O: the tool shift direction in the
cycles of G76 and G77 to be
specified in and D of parameter
#6019 (specifiable only
D’ D4 D3 D2 DO
D7
D6
D5
D4
D3
D2
0:
0:
1:
0:
0:
1:
0:
1:
0:
1:
0:
1:
0:
Assigns selection of group specifica-
tion numbers to an external signal
when the tool change skip signal is
ON during life control.
Assigns selection of group specifica-
tion numbers to the currently specified
group when the tool change skip signal
is
during c o n t r o l .
Assigns selection of the T command group to
the T command immediately before during
the M06 command in life control.
Assigns selection of the T command
to the latest T command during the
M06 command in life control.
Assigns group number specification
to an external signal during tool change
reset in life control.
Assigns group number specification
to setting #6204 during tool change
reset in life control.
Counts with when count is
the type of life control.
Counts with when count
is the type of life control.
Sets (in/rev) for the feed per
minute in the inch system.
Sets F13 (in/rev) for the feed per
minute in the inch system.
Sets F23 (mm/rev) for the feed per
minute in the metric system.
Sets F22 (mm/rev) for the feed per minute in
the
system.
Sets F32 (in/min.) for the feed per minute in
the inch system.
Sets F31 (in/min.) for the feed per minute in
the inch system.
Sets (mm/min. )
minute in the metric
Sets F50 (mm/min. )
in the metric
for feed per
system
for the feed per
system.
217