Yaskawa J50M Instructions - Manual (Page 211)

D3 D2
D7
D6
D5
D4
D3
D2
DO
The group G02 G code upon reset is;
O: G17.
1: The G code commanded immediately
before is retained.
1: Cancels life data when executing
command G 122
0: Does not cancel life data when
executing command G 122
The group G03 G code upon reset ;
O : #6005 DO.
1: The G code commanded immediately
before is retained.
1: Programs of program numbers
8000 through 8999 cannot be
r e g i s t e r e d , erased or edited.
O: Normal registration, erasure
and editing can be performed.
1: Programs with program numbers
8000 through 8999 will not be
d i s p l a y e d .
O: Programs with program numbers
8000 through 8999 will be dis-
p l a y e d .
O-number automatic renaming function is ;
1: Validated.
O : Invalidated.
1: Single blocks become effective
in relation to an operation com-
mand from the user program.
O: Single blocks become ineffective
in relation to operation commands
or control commands from the
user program.
1: The next block will be executed
if there is no skip signal input
until shifting of the G31 block
e n d s .
O: Causes alarm “087”
I ‘ 1
Break point
Break point sequence setting.
Setting range : 1 to 9999.
Will not stop at
the program of a macro program
to be called by B code.
Setting range : 1 to 9999
Group number specification during tool change
and reset.
Setting range : 1 to 256
Program No. setting
Specifies program number of tape when
inputting tape without a program number.
Setting range : to 9999
Note: If O is set, input error may cause except
when the number on the upper right of CRT is “O. ”
Dwell time setting when executing
G76 and G77
Setting : “ 1“ = 1 ms
Setting range : 0 to 32767
Amount of setting when executing G73
Setting : “l” = 0.001 mm or 0.0001 inch
Setting range : 0 to 32767
Default dwell time setting for
Setting :
“l” = 1 ms
Setting range : 0 to 32767
Shift amount “ setting when executing G83
Setting : “l” = 0.001 mm or 0.0001 inch
Setting range : 0 to 32767
Automatic corner override Al point
(n% of tool radius)
Setting : “ 1“ =
Automatic corner override A2 point
radius)
Setting : “ 1“ =
Automatic corner override
(n% of command feeding)
Setting : “ 1“ = l%
203