Yaskawa J50M Instructions - Manual (Page 160)

4.4.2 INPUTTING SETTING DATA AND PARAMETER
DATA
Though setting data and parameter data are normally
input by MDI operation, they can also be entered by
means of paper tape. Setting data and parameter data
can be input from a single tape.
1. The tape format is as follows.
Label ;
N 6 0 0 0 x 1 2 8 ;
x ;
N6002 X O ;
. .
. .
. .
N o t e :
“%” is used in
the ISO code and
“ER” in the EIA
code.
2. The input operation is as follows.
A .
B .
c .
D.
E.
F.
4.4.3
Select EDIT mode.
Depress the RESET key.
Deprss the PRM key.
Set the setting /parameter data tape onto
the tape reader.
Depress IN key.
The tape reader starts reading the tape.
“IN blinks on the CRT while the data are read.
The tape reader stops when it has read (or
and “IN” disappears from the CRT.
Now the setting/parameter data have been read
into memory.
Turn on power again because the control is in
the HOLD state (key inoperative) at completion
of input.
OUTPUTTING TOOL OFFSETS TO PAPER TAPE
The tool offset data set in the system can be output to
paper tape.
1. The output operation is as follows .
A .
B.
c.
D.
E.
Select EDIT mode
Depress the RESET key.
Depress the OFS key.
Check that the punch is ready for opera-
tion.
Depress OUT key.
The paper tape punch punches the tool
offset data onto paper tape and stops auto-
matically when all contents of the tool
off-
set memory have been output.
F. To suspend the operation, depress the
RESET key.
At this time, the output operation cannot
be resumed.
Restart from the beginning.
2. The tape format is the same as that describ-
ed in 4.4.1, “ INPUTTING TOOL OFFSETS
FROM
4.4.4 OUTPUTTING SETTING DATA AND
PARAMETER DATA TO PAPER TAPE
1. The output operation is as follows.
A .
B.
c.
D.
E.
F.
Select EDIT mode.
Depress the RESET key.
Depress the PRM key.
Check that the punch is ready for opera-
tion .
Depress the OUT key.
The paper tape punch punches the setting/
parameter data onto paper tape
.
To suspend the operation, depress the
RESET key.
At this time, the output operation cannot
be resumed.
Restart from the beginning.
2. The tape format is the same as that described
in 4.4.2, “INPUTTING SETTING DATA AND
PARAMETER DATA .“
4.4.5 OUTPUTTING PART PROGRAM TO PAPER TAPE
(1)
a.
b .
e.
f .
h.
The part program of the designated program
number is punched out by the following
operations :
Connect the external equipment such as
the tape puncher to the NC via the data
input /output interface.
Make the external equipment relay for
operation.
Turn on the NC power.
Select the EDIT mode.
Depress the PROG function key.
Check to see if the external equipment is
ready.
Depress the RESET key.
Depress “O” key and key in program number.
152