Yaskawa J50M Instructions - Manual (Page 240)

PARAMETER NUMBERS AND THEIR CONTENTS
#6350 to #6353 :
Specifies the rapid traverse acceleration/deceleration
constants X-, Y-, Z- and 4th-axes handle feed, respec-
tively.
Setting : l m s
Setting range : 8 to 32767
For tool pot indication
Sets
#6356: Sets
#6359
tool pot indication start No.
tool pot indication end No.
X-axis
Y-axis
Z–axi s
to #6359:
Specifies the time between ESP and SVOFF for X-,
and Z-axis, respectively.
Setting : “l” = 8 ms
Setting range :
#6363
,
r 1
# 6 3 6 2 :
# 6 3 6 3 :
# 6 3 6 4 :
O to 32767
1
pot SP
pot MG
pot WT
By the input of x1OO, the scale factor of handle
becomes effective.
Setting : “ 1“ = 1
Title display code setting after turning the power on :
1st line
Title display code setting after turning the power on :
2nd line
X–axis
I
Y-axis
Z – a x i s
4th axis
Spindle
compensation values shown in the order of
X-, Y-, Z-, 4th-axes and spindle.
Setting: = 1 pulse
S e t t i n g r a n g e : O t o
Note: Be sure to turn the on and off
after changing the parameter.
X – a x i s
Y – a x i s
Z – a x i s
1
4th axis
S p i n d l e
Command unit position loop gains are set in the order
of X-, Y-, Z-, 4th-axes and spindle.
Setting : “l” = 0.01 s
Setting range : 0 to 32767
[ #6412
,
X-axi s
s
I
I
4th axis
1
Acceleration and deceleration time constants for con-
trol unit during normal cutting are set in the order of
X-, Y-, Z- and 4th-axes.
232