Yaskawa J50M Instructions User Manual
Page 233
r
Setting : “ 1“ = 1 pulse
Setting range : 0 to 255
Note :
Be sure to turn
changing the parameter.
the power on and off after
Spindle error detect on area (for solid tap)
Setting:
= 1 pulse
Setting range: O to 255
Note :
Be sure to turn the power on and off after
changing the parameter #6150 to #6161.
M codes to stop advance reading setting expanded
area.
Set pitch error compensation setting pulse mul-
tiplication factor for X-, Y-, Z- and 4th axes respectively.
Setting : “ 1” = 1 multiplication
Setting range: O to 3
Spindle error detect ON
Setting:
“ 1“ = 1 pulse
Setting range: O to 255
,
1
area (for spindle indexing)
Number of teeth on the spindle side gear
Setting : “ 1“ = 1
Setting range : 0 to
I
Number of teeth on the spindle intermediate gear
Setting : “ 1“ = 1 tooth
Setting range : 0 to 127
Number of teeth on the motor intermediate gear
Setting : “l” =
Setting range :
#6199
1 tooth
O to 127
I
Number of teeth on the motor side gear
Setting : “ 1“ = 1 tooth
Setting range : 0 to 127
Specifies the interval from the time, M, S, T and B
codes are transmitted until the time MF, SF, TF
and BF are transmitted.
This parameter must be a multiple of 8.
Setting :
“l” = 1 ms
Setting range : 0 to 32767
Time from gear output
sending to SF
sending at S. D/A or
output.
Setting : “l” = 1 ms
Setting range : 0 to
32767
Specifies the maximum handle feedrate, which is
common to the linear axes (X, Y, Z, U, V, W).
Setting : “ 1“ = 1 mm/min or 0.1 inch/rein
Setting range : 0 to 30000
Note :
The settings for the rotary axes
(A, B, C) are made with #6348.
Specifies the tool shift speed for canned cycles of
G76 and G77.
Setting :
“l” = 1
Setting range : 0 to 30000
225