Yaskawa J50M Instructions User Manual
Page 171
4.8.4 SUMMARY OF EDITING OPERATION
Edit
No.
switch
1
PRM
Mode
Procedure
Parameter number -
+
Data
Operation
Storing from NC operator’s panel
keyboard
Storing from tape (Note 1) (Note 2)
1
EDIT
/
Punch out (Note 3)
Matching with tape (Note 1]
Storing from NC operator’s panel
keyboard
Setting number
Data
-
Offset number
Address data
Storing from NC operator’s panel
keyboard
Storing from tape
Punch out
OFS
Matching with tape
Clear of all offsets
1
OFF
OFF
OFF
One
Tape with number O
part
program Tape without number
(Note 4)
❑
-, Program number
from
tape
All part
programs on tape
Addition to registered part
program
Designated part program
OFF
I
1
Punch
out
with
tape
❑
- -9999-.
All
part programs
Program number -
to
be
Address data -- ALTER
[Set to address data just before
addition) -
to address data to be deleted)
(Set address data at head of
to be deleted)
Address data to be searched
to be searched
❑
“
“
with number O
EDIT
M E M
EDIT
PROG
All part
programs on tape
of address data (Note 5)
OFF
I
OFF
I
Add of address data (Note 5)
Edit
OFF
OFF
Delete of one address data
Delete of one block (Note 6)
Address search
PROG
or
ALM
OFF
EDIT
Notes :
1. If the
tape contains setting information, it is also stored and
5. Within the limit of 32 characters, addition of multiple address
matched at the same time.
data and the change to one address data are permitted.
When the cursor to the address data
in the middle of a block
and EOB and ERASE keys are depressed, the data following
the cursor position is deleted.
2. When data has been stored from a parameter tape, turn the 6.
power on and off.
3. Setting is punched out at the same time.
4. Storing of a part program having a program number different
from program number O on tape is performed by the same
operation as for “tape without program number O.
163