Yaskawa J50M Instructions - Manual (Page 279)

Code
312
- - -
Causes Causes
322
--- ---
Y-AXIS SERVO UNREADY
------- --------------- ------ -------- ------ . .
Y-AXIS SERVO NOT READY
CMOS VACANT AREA ERROR
----- ----------------- ------ --- ----- -----
THE UNUSED AREA OF THE CMOS IS USED.
(THE CMOS MAY BE DESTROYED. )
IN TO RESET E R R O R . )
313
------ .
323
-- . . . . .
Z-AXIS SERVO
------ ----- ----------- ----- ---------- . .
Z-AXIS SERVO NOT READY
314 324
----- .
325
4TH AXIS SERVO UNREADY
----- ----- ------ ----- ------ ----- .
4TH AXIS SERVO NOT READY
315
- - - - - -
SERVO CPU ERROR
----- ----------------- ---- -----
SERVO CPU IS IN ABNORMAL STATE.
(SET “O IN
TO
THE ERROR).
316
- - . - - -
326 SKIP MACRO (G, M, T)
---------------- --------------- ------ ----
CALLING OF G, M, T
MACRO OF THE MAIN
PROGRAM WAS SKIPPED
(CHECK MODE) .
317
----- .
NO PROG GEN
_ —-------- ---- —- —-- -- ---
MEMORY LENGTH , ‘ -
MEMORY GENERATION WAS
NOT PERFORMED , HAS BEEN
CHANGED BUT NO GENERATION
HAS BEEN MADE.
327 318
—..-
319
320
--
NC UNREADY
------ ------- ------- -- _-. —— _ ----.—-
NC UNREADY P SET NOT READY
328
- . .
UNSUITABLE MM51
______
MEMORY LENGTH DOES NOT MATCH
THE MEMORY BOARD.
PC CPU ERROR
----- -
PC CPU IS IN ABNORMAL STATE.
(SET “O” IN
D7 TO RESET
THE ERROR).
329 321
271