Yaskawa J50M Instructions - Manual (Page 169)

4.7.5 OPERATIONS USING DATA
INTERFACE
The use of data input/output interface allows the
following operations and runs:
(1) The input /output operations of tool offset
amounts, setting data, and parameter data and
the output operations (punch out) of part pro-
grams. For details, see 4.4, “TAPE INPUT/
OUTPUT OPERATIONS
OF NC DATA.
(2) The storing of part programs into memory.
For details, see 4.5, “LOADING PART PROGRAMS
INTO MEMORY’.
(3) Tape-verification of part programs, tool off-
set amount, setting data, and parameter data,
For details, see 4.8,
4.8 TAPE VERIFYING
The punched tape of the data shown below
be
compared to
memory to check if
. Part program
. Tool
. Setting
contents of the NC internal
they match.
parameter
The punched tape is entered through the NC tape
reader or the data input/output interface (option). For
the methods of setting the input/output equipment (set-
ting #6003) and the baud rate (parameters #6026
through #6029), refer to 4.7 “SUPPLEMENT TO DATA
INPUT/OUTPUT INTERFACE
The following descrip-
tion is made assuming that this option is installed.
4.8.1 SETTING AND PARAMETER TAPE VERIFYING
1.
2.
3.
5.
6.
Select “ 1“ of system No. switch.
Set the MODE SELECT switch to the EDIT.
Depress PRM function key.
Depress RESET key.
Load the NC tape via tape reader.
Depress VER key.
Tape starts, and the contents of tape and
the contents of setting /parameter are veri-
fied.
blinks on the CRT.
If disagreement with the tape data is
ERROR” blinks on the
After completion of verifying without dis-
agreement , tape reader stops and
dis-
appears.
4.8.2 TOOL OFFSET VALUE TAPE VERIFYING
2.
3.
4.
5.
6.
4.8.3
(1)
a.
b.
c.
d.
e.
(2)
a.
b.
c.
d.
e.
Set the MODE SELECT switch to the EDIT.
Depress OFS function key.
Depress RESET key.
Load the source tape via tape reader .
Depress VER key
Tape starts , and the contents of tape and
the contents of tool offset values are verifi-
ed.
If disagreement with the tape data is
detected, “INPUT ERROR” blinks on the
CRT .
After completion of verifying without dis-
agreement, tape reader stops and
disappears.
VERIFYING PART PROGRAM TAPE
Verifying a part program tape having pro-
gram number
Select the EDIT mode.
Depress the PROG function key .
Set the part program tape to the tape reader.
Depress the RESET key.
Depress the VER key.
The tape is started to compare the
tents of the part program memory to the
contents of the part program tape.
During
this operation , blinks . If
a mismatch is found , “INPUT ERROR”
blinks on the CRT.
When a match is found and this operation is.
completed, the tape reader stops , upon
which
display erased.
Note: By the operation of “RESET , VER, “
the verifying feature verifies the data from
the tape head to code.
Verifying a part program tape having no
program number
Select the EDIT mode .
Depress PROG function key.
Set the part to the tape reader.
Depress the RESET key .
Depress
key in program
number.
161