Motorola MPC8260 - Manual (Page 583)

MOTOROLA Chapter 19. Serial Communications Controllers (SCCs) 19-27
Part IV. Communications Processor Module
4. If an INIT TX PARAMETERS command was not issued in step 3, issue a RESTART
TRANSMIT command.
5. Set GSMR_L[ENT]. Transmission begins using the TxBD pointed to by TBPTR,
assuming the R bit is set.
19.3.8.2 Reset Sequence for an SCC Transmitter
The following steps reinitialize an SCC transmit parameters to the reset state:
1. Clear GSMR_L[ENT].
2. Make any modiÞcations then issue the INIT TX PARAMETERS command.
3. Set GSMR_L[ENT].
19.3.8.3 General ReconÞguration Sequence for an SCC Receiver
An SCC receiver can be reconÞgured by following these steps:
1. Clear GSMR_L[ENR]. The SCC receiver is now disabled and put in a reset state.
2. Modify SCC Rx parameters or parameter RAM. To switch protocols or restore Rx
parameters to their initial state, issue an INIT RX PARAMETERS command.
3. If the INIT RX PARAMETERS command was not issued in step 2, issue an ENTER HUNT
MODE command.
4. Set GSMR_L[ENR]. Reception begins using the RxBD pointed to by RBPTR,
assuming the E bit is set.
19.3.8.4 Reset Sequence for an SCC Receiver
To reinitialize the SCC receiver to the state it was in after reset, follow these steps:
1. Clear GSMR_L[ENR].
2. Make any modiÞcations then issue the INIT RX PARAMETERS command.
3. Set GSMR_L[ENR].
19.3.8.5 Switching Protocols
To switch an SCCÕs protocol without resetting the board or affecting other SCCs, follow
these steps:
1. Clear GSMR_L[ENT, ENR].
2. Make protocol changes in the GSMR and additional parameters then issue the INIT
TX and RX PARAMETERS command to initialize both Tx and Rx parameters.
3. Set GSMR_L[ENT, ENR] to enable the SCC with the new protocol.
19.3.9 Saving Power
To save power when not in use, an SCC can be disabled by clearing GSMR_L[ENT, ENR].