Motorola MPC8260 - Manual (Page 684)

24-16 MPC8260 PowerQUICC II UserÕs Manual MOTOROLA
Part IV. Communications Processor Module
Table 24-6 describes PSMR Þelds.
Table 24-6. PSMR Field Descriptions
Bits Name Description
0 HBC Heartbeat checking.
0 No heartbeat checking is performed. Do not wait for a collision after transmission.
1 Wait 20 transmit clocks or 2 µs for a collision asserted by the transceiver after transmission. The HB
bit in the TxBD is set if the heartbeat is not heard within 20 transmit clocks.
1 FC Force collision.
0 Normal operation.
1 The channel forces a collision when each frame is sent. To test collision logic conÞgure the
MPC8260
in loopback operation. In the end, the retry limit for each transmit frame is exceeded.
2 RSH Receive short frames.
0 Discard short frames that are not as long as MINFLR.
1 Receive short frames.
3 IAM Individual address mode.
0 Normal operation. A single 48-bit physical address in PADDR1 is checked when it is received.
1 The individual hash table is used to check all individual addresses that are received.
4Ð5 CRC CRC selection. Only CRC = 10 is valid. Complies with Ethernet speciÞcations. 32-bit CCITT-CRC.
X32 + X26 + X23 + X22 + X16 + X12 + X11 + X10 + X8 + X7 + X5 + X4 + X2 + X1 +1.
6 PRO Promiscuous.
0 Check the destination address of incoming frames.
1 Receive the frame regardless of its address unless REJECT is asserted as it is being received.
7 BRO Broadcast address.
0 Receive all frames containing the broadcast address.
1 Reject all frames containing the broadcast address, unless PRO = 1.
8 SBT Stop backoff timer.
0 The backoff timer is functioning normally.
1 The backoff timer for the random wait after a collision is stopped when carrier sense is active.
Retransmission is less aggressive than the maximum allowed in IEEE 802.3. The persistence
(P_PER) feature in the parameter RAM can be used in combination with or in place of SBT.
9 LPB Local protect bit
0 Receiver is blocked when transmitter sends (default).
1 Receiver is not blocked when transmitter sends. Must be set for full-duplex operation. For loopback
operation, GSMR[DIAG] must be programmed also; see Section 19.1.1, ÒThe General SCC Mode
Registers (GSMR1ÐGSMR4).У
10 С Reserved. Should be cleared.
11 LCW Late collision window.
0 A late collision is any collision that occurs at least 64 bytes from the preamble.
1 A late collision is any collision that occurs at least 56 bytes from the preamble.