Allied Telesis AT-S63 - Manual (Page 101)

AT-S63 Management Software Web Browser Interface User’s Guide
Section I: Basic Features 101
The Add New Trunk page is shown in Figure 28.
Figure 28. Add New Trunk Page
5. Adjust the following parameters as necessary.
Trunk Name
The name for the port trunk. The name can be up to 16
alphanumeric characters. No spaces or special characters, such as
asterisks and exclamation points, are allowed. Each trunk must be
given a unique name.
Trunk Method
Select a load distribution method. The possible settings are:
SA - Source MAC address (Layer 2)
DA - Destination MAC address (Layer 2)
SA/DA - Source MAC address /destination MAC address (Layer 2)
SI - Source IP address (Layer 3)
DI - Destination IP address (Layer 3)
SI/DI - Source IP address /destination IP address (Layer 3)
6. Click the ports that are to make up the port trunk. A selected port
changes to white. An unselected port is black. A port trunk can
contain up to eight ports.
Note
All ports in a trunk must operate at the same speed. When you
include port 23R or 24R in a trunk and the port transitions to
redundant uplink status, the port speed is automatically adjusted to