Allied Telesis AT-S63 - Manual (Page 286)

Chapter 18: GARP VLAN Registration Protocol (GVRP)
286 Section III: VLANs
Configuring GVRP
To configure GVRP, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Layer 2option.
The Layer 2 page is displayed with the MAC Address tab displayed
by default, as shown in Figure 23 on page 90.
3. Select the GVRP tab.
The GVRP tab is shown in Figure 106.
Figure 106. GVRP Tab (Configuration)
4. In the GVRP Parameters section, adjust the following parameters as
necessary.
Enable GVRP
Click to enable or disable GVRP.
Leave Time
Use this parameter to specify the leave time. The range is 30 to 80
centiseconds and the default is 60 centiseconds.