Allied Telesis AT-S63 - Manual (Page 210)

Chapter 16: SNMPv3
210 Section II: Advanced Features
None
Select this value if you do not want a privacy protocol for this User
Table entry. With this selection, messages transmitted between
the host and the switch are not encrypted.
10. In the Privacy Password field, enter a privacy password of up to 32
alphnumeric characters.
11. In the Confirm Privacy Password field, re-enter the privacy password.
12. In the Storage Type field, enter one of the following storage options
for this table entry:
Volatile
Select this storage type if you do not want the ability to save an
entry in the User Table. After making changes to an User Table
entry with a Volatile storage type, Save Changes does not appear
on the General tab.
NonVolatile
Select this storage type if you want the ability to save an entry in
the User Table. After making changes to an User Table entry with
a NonVolatile storage type, Save Changes appears on the General
tab. Allied Telesyn recommends this storage type.
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 User Table entry
takes effect immediately.
13. Click Apply to update the SNMPv3 User Table.
14. To save your changes, return to the General tab and click Save
Changes.
Deleting a User
Table Entry
To delete an entry in the SNMPv3 User Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure User Table
and then click Configure.
The SNMPv3 User Table tab is shown in Figure 70 on page 208.