Configuring the snmpv3 access table, Creating an access table – Allied Telesis AT-S63 User Manual
Page 220
Chapter 16: SNMPv3
220
Section II: Advanced Features
Configuring the SNMPv3 Access Table
You can create, delete, and modify an SNMPv3 Access Table entry. See
the following procedures:
❑ ”Creating an Access Table” on page 220
❑ ”Deleting an Access Table Entry” on page 224
❑ ”Modifying an Access Table Entry” on page 224
For information about the SNMPv3 Access Table, see Chapter 18,
“SNMPv3” in the AT-S63 Management Software Menus Interface User’s
Guide.
Creating an
Access Table
To create an entry in the SNMPv3 Access Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure Access
Table and then click Configure at the bottom of the tab.
The SNMPv3 Access Table tab is shown in Figure 76.