Allied Telesis AT-S63 - Manual (Page 207)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 207
Configuring the SNMPv3 User Table
You can create, delete, and modify an SNMPv3 User Table entry. See the
following procedures:
❑ ”Creating a User Table Entry” on page 207
❑ ”Deleting a User Table Entry” on page 210
❑ ”Modifying a User Table Entry” on page 211
For reference information about the SNMPv3 User Table, see Chapter 18,
“SNMPv3” in the AT-S63 Management Software Menus Interface User’s
Guide.
Creating a User
Table Entry
To create an entry in the SNMPv3 User Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 69 on page 205.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure User Table
and then click Configure at the bottom of the tab.