Allied Telesis AT-S63 - Manual (Page 195)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 195
Configuring MSTP Port Parameters
To configure MSTP port parameters, perform the following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected
by default, as shown in Figure 23 on page 90.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 61 on page 182.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 62 on
page 185.
5. In the diagram of the switch at the bottom of the MSTP Spanning Tree
Expanded page, click the ports you want to configure. You can select
more than one port at a time.
6. Click Modify.
The MSTP Settings - Port(s) page is shown in Figure 65.
Figure 65. MSTP Settings - Port(s) Page
7. Adjust the following parameters as necessary.
Port Priority
This parameter is used as a tie breaker when two or more ports are
determined to have equal costs to the regional root bridge. The