Allied Telesis AT-S63 - Manual (Page 307)

AT-S63 Management Software Web Browser Interface User’s Guide
Section IV: Security 307
The Security for Port(s) page is shown in Figure 115.
Figure 115. Security for Port(s) Page
The Security for Ports page displays a table that contains the
following columns of information:
Port
The number of the port.
Security Mode
The active security mode on the switch.
Intruder Action
The column specifies the action taken by the switch if a port
receives an invalid packet. The possible settings are:
No Action (Discard) - The port discards invalid packets. This is the
default.
Trap - The port discards invalid packets and sends a trap.
Trap/Disable - The port discards invalid packets, sends a trap, and
disables the port.
Participating
This column applies only when the intrusion action for a port is set
to trap or disable. This option does not apply when intrusion
action is set to No Action (discard). If this option is set to No when
intrusion action is set to trap or disable, the port discards invalid
packets, but it does not send a trap or disable the port.
MAC Limit
This column specifies the maximum number of dynamic MAC
addresses the port learns. It only applies when a port is operating
in the Limited security mode.