Allied Telesis AT-S63 - Manual (Page 60)

Chapter 4: SNMPv1 and SNMPv2c
60 Section I: Basic Features
5. Modify the following parameters:
Community Name
This field is not configurable from this page. It is the name of the
SNMP community.
Status
Click Enable to enable the SNMP community. Click Disable to
disable the SNMP community.
Access Mode
Click Read Only to allow read access to the SNMP community.
Click Read-Write to allow read-write access to the SNMP
community.
Allow Any Station
Click this option to allow any SNMP manager to access the switch.
When you click this option, a warning message appears on the
screen. Click OK to continue.
Manager IP Address1 through Manager IP Address 8
Enter an IP Address of a switch that is permitted SNMP manager
access to the current switch. You can enter up to 8 Manager IP
Addresses.
Trap Receiver IP Address 1 through Trap Receiver IP Address 8
Use the above selections to specify the IP addresses of up to 8 trap
receivers on your network that can receive traps from the switch.
6. Click Apply.
7. To save your changes, return to the General tab and click Save
Changes.