Allied Telesis AT-S63 - Manual (Page 145)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 145
Mapping CoS Priorities to Egress Queues
This procedure explains how to change the default mappings of CoS
priorities to egress priority queues, as shown in Table 3 on page 143. This
is set at the switch level. You cannot set this on a per-port basis.
To change the mappings, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the QoS option.
The QoS page is displayed with the CoS tab selected by default, as
shown in Figure 40 on page 142.
3. Select the Scheduling tab.