Allied Telesis AT-S63 - Manual (Page 312)

Chapter 20: Encryption Keys, PKI, and SSL
312 Section IV: Security
Displaying the PKI Settings and Certificates
You can view the current PKI settings and certificates on the switch. To
configure the PKI settings and certificates, you must use the AT-S63
menus or command line interface. For more information about PKI, refer
to the AT-S63 Management Software Menus Interface User’s Guide.
To display the PKI settings and certificates, perform the following
procedure:
1. From the Home page, select Monitoring.
The System page is displayed with the General tab selected by
default, as shown in Figure 6 on page 44.
2. From the Monitoring menu, select the Security option.
The Security page is displayed with the 802.1x Port Access tab
displayed by default, as shown in Figure 116 on page 310.
3. Select the PKI tab.
The PKI tab is shown in Figure 118.
Figure 118. PKI Tab (Monitoring)
The upper section states the maximum number of certificates that
can be configured on the switch.
The lower section displays a table that lists the currently
configured certificates and contains the following columns of
information: