Allied Telesis AT-S63 - Manual (Page 246)

Chapter 16: SNMPv3
246 Section II: Advanced Features
The Add New SNMPv3 Target Parameter page is shown in Figure
89.
Figure 89. Add New SNMPv3 Target Parameters Page
5. In the Target Parameters Name field, enter a name of the SNMP
manager or host.
Enter a value of up to 32 alphnumeric characters.
Note
Enter a value for the Message Processing Model parameter only if
you select SNMPv1 or SNMPv2c as the Security Model. If you select
the SNMPv3 protocol as the Security Model, then the Message
Processing Model is automatically assigned to SNMPv3.
6. In the Message Processing Model field, enter a Security Model that is
used to process messages.
Select one of the following SNMP protocols:
v1
Select this value to process messages with the SNMPv1 protocol.
v2c
Select this value to process messages with the SNMPv2c protocol.
v3
Select this value to process messages with the SNMPv3 protocol.
7. In the Security Model field, select one of the following SNMP protocols
as the Security Model for this Security Name, or User Name.