Allied Telesis AT-S63 - Manual (Page 189)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 189
Creating, Deleting, or Modifying MSTI IDs
To create, delete, or modify MSTI IDs, perform one of the following
procedures.
Creating an
MSTI ID
To create an MSTI ID, perform the following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected
by default, as shown in Figure 23 on page 90.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 51 on page 164.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 62 on
page 185.
5. In the CIST/MSTI Table section of the tab, click Add.
The Add New MSTI page is shown in Figure 63.
Figure 63. Add New MSTI Page
6. In the MSTI ID field, enter a new MSTI ID. The range is 1 to 15.
7. In the Priority field, enter an MSTI Priority value. This parameter is
used in selecting a regional root for the MSTI. The range is 0 (zero) to
61,440 in increments of 4,096, with 0 being the highest priority. This