Allied Telesis AT-S63 - Manual (Page 243)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 243
Use the following format for an IP address:
XXX.XXX.XXX.XXX
7. In the UDP Port Number field, enter a UDP port number.
You can enter a UDP port in the range of 0 to 65,535. The default
UDP port is 162.
8. In the Timeout field, enter a timeout value in milliseconds.
When an Inform message is generated, it requires a response from
the switch. The timeout value determines how long the switch
considers the Inform message an active message. This parameter
applies to Inform messages only. The range is from 0 to
2,147,483,647 milliseconds. The default value is 1500
milliseconds.
9. In the Retries field, enter the number of times the switch retries, or
resends, an Inform message.
When an Inform message is generated, it requires a response from
the switch. This parameter determines how many times the
switch resends an Inform message. The Retries parameter applies
to Inform messages only. The range is 0 to 255 retries. The default
is 3 retries.
10. In the Tag List field, enter a list of tags that you configured with the
Notify Tag parameter in a Notify Table entry.
See ”Creating a Notify Table Entry” on page 233. Enter a Tag List of
up to 256-alphanumeric characters. Use a space to separate
entries, for example:
hwengtag swengtag testengtag
11. In the Target Parameters field, enter a Target Parameters name.
This name can consist of up to 32 alphnumeric characters. The
value configured here must match the value configured with the
Target Parameters Name parameter in the Target Parameters
Table.
12. In the Storage Type field, enter one of the following storage types for
this table entry:
Volatile
Select this storage type if you do not want the ability to save an
entry in the Target Address Table. After making changes to a
Target Address Table entry with a Volatile storage type, Save
Changes does not appear on the General tab.