Allied Telesis AT-S63 - Manual (Page 137)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 137
Disabling the Event Log
To activate or deactivate the event log, perform the following
procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. Select the Event Log tab.
The Event log tab is shown in Figure 36 on page 128.
3. In the Log Settings section, for the Status, click Disabled.
4. Click Apply to activate the settings on the switch.
5. Select the General tab.
6. Click Save Changes to permanently save your changes. (This button
is not displayed if there are no changes to save.)