Allied Telesis AT-S63 - Manual (Page 241)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 241
Volatile
Select this storage type if you do not want the ability to save an
entry in the Target Address Table. After making changes to a
Target Address Table entry with a Volatile storage type, Save
Changes does not appear on the General tab.
NonVolatile
Select this storage type if you want the ability to save an entry in
the Target Address Table. After making changes to a Target
Address Table entry with a NonVolatile storage type, Save
Changes appears on the General tab. Allied Telesyn recommends
this storage type.
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 Target Address
Table entry takes effect immediately.
13. Click Apply to update the SNMPv3 Target Address Table.
14. To save your changes, return to the General tab and click Save
Changes.
Deleting a
Target Address
Table Entry
To delete an entry in the SNMPv3 Target Address Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure Target
Address Table and then click Configure at the bottom of the tab.
The SNMPv3 Target Address Table tab is shown in Figure 85 on
page 239.
4. Click Next or Previous to display the SNMPv3 Target Address Table
entry that you want to delete.
5. Click Remove.
A warning message is displayed.
6. Click OK.