Pinging a remote system – Allied Telesis AT-S63 User Manual
Page 49
AT-S63 Management Software Web Browser Interface User’s Guide
Section I: Basic Features
49
Pinging a Remote System
You can instruct the switch to ping a node on your network. This
procedure is useful in determining whether a valid link exists between
the switch and another device.
To ping a network device, perform the following procedure:
1. From the home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 44.
2. Select the Ping Client tab.
The Ping Client tab is shown in Figure 7.
Figure 7. Ping Client Tab (Monitoring)
3. Enter the IP address of the end node you want the switch to ping.
4. Click OK.
The results of the ping are displayed in a popup window.
5. To stop the ping, click OK.