Configuring an ip address and switch name – Allied Telesis AT-S63 User Manual
Page 40
Advertising
Chapter 3: Basic Switch Parameters
40
Section I: Basic Features
Configuring an IP Address and Switch Name
Note
For guidelines about when to assign an IP address, subnet address,
and gateway address to an AT-9400 Series switch, refer to “When
Does a Switch Need an IP Address?” in Chapter 3, “Basic Switch
Parameters,” in the AT-S63 Management Software Menus Interface
User’s Guide.
To set basic switch parameters for an AT-9400 Series switch, perform the
following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5.
Figure 5. General Tab (Configuration)
Advertising