Allied Telesis AT-S63 - Manual (Page 348)

Chapter 23: 802.1x Port-based Network Access Control
348 Section IV: Security
The Security page is displayed with the 802.1x Port Access tab
selected by default, as shown in Figure 138.
Figure 138. 802.1x Port Access Tab (Monitoring)
The RADIUS Accounting section provides the following
information:
Accounting
The status of RADIUS accounting, either Enabled or Disabled.
Trigger Type
The action that causes the switch to send accounting information
to the RADIUS server. The possible settings are:
Start_Stop - The switch sends accounting information whenever a
client logs on or logs off the network. This is the default.
Stop - The switch sends accounting information only when a client
logs off.
Port Number
The UDP port for RADIUS accounting.
Type
The type of RADIUS accounting. The default is Network.