Rebooting a switch – Allied Telesis AT-S63 User Manual
Page 48
Chapter 3: Basic Switch Parameters
48
Section I: Basic Features
Rebooting a Switch
Note
Any parameters changes that have not been saved are discarded
when a system is reset. To save parameter changes, refer to ”Saving
Your Parameter Changes” on page 36.
To reboot a switch, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. Click Reset.
A confirmation prompt is displayed.
3. Click OK to reset the switch or Cancel to cancel the procedure:
Note
The switch does not forward packets while it reloads the AT-S63
management software, a process that takes approximately 20
seconds to complete.
Resetting the switch ends your web browser management
session. You must restart the session to continue managing the
switch.