Resetting a port to the default settings – Allied Telesis AT-S63 User Manual
Page 88
Chapter 6: Port Parameters
88
Section I: Basic Features
Resetting a Port to the Default Settings
To reset a port to the default settings, perform the following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Layer 1 option.
3. Select the Port Settings tab.
The Port Settings tab is shown in Figure 18 on page 74.
4. Click the port in the graphical switch image that you want to
configure. The selected port turns white. You can select more than
one port at a time to configure. (To deselect a port, click it again.)
5. Click Modify. To configure all of the ports, click Modify All.
The Port Configuration page is shown Figure 19 on page 75.
6. Click Defaults.
The port(s) are returned to the default settings listed in Appendix
A, ”AT-S63 Default Settings” on page 357.