Allied Telesis AT-S63 - Manual (Page 112)

Chapter 9: Port Mirroring
112 Section I: Basic Features
Figure 33 shows an example of the Modify Mirror page configured
for a port mirror. The egress traffic on ports 11 and 12 is being
mirrored to the destination port 5.
Figure 33. Example of a Modify Mirror Page
6. After selecting the destination and source ports, click the Enable
Mirror check box.
7. Click Apply.
The port mirror is now active on the switch. You can connect a
data analyzer to the destination port to monitor the traffic on the
source ports.
8. To permanently save the change, return to the General tab on the
System page and click Save Changes.
For more information about what the Save Changes button does,
refer to ”Saving Your Parameter Changes” on page 36.