Enabling or disabling snmp management – Allied Telesis AT-S63 User Manual
Page 54
Chapter 4: SNMPv1 and SNMPv2c
54
Section I: Basic Features
Enabling or Disabling SNMP Management
To enable or disable SNMP management on the switch, perform the
following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 9.
Figure 9. SNMP Tab (Configuration)
3. Click the Enable SNMP Access checkbox to enable or disable SNMP
management. A check in the box indicates that the feature is enabled,
meaning that the switch can be managed from an SNMP
management station. No check indicates that the feature is disabled.
The default is disabled.
4. If you want the switch to send authentication failure traps, click the
Enable Authentication Failure Traps checkbox. A check in the box
indicates that the switch sends the trap.