Allied Telesis AT-S63 - Manual (Page 266)

Chapter 16: SNMPv3
266 Section II: Advanced Features
Displaying
Target
Parameters
Table Entries
To display entries in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 94 on page 259.
3. In the SNMPv3 section, click the button next to the View Target
Parameters Table and then click View at the bottom of the tab.
The SNMPv3 Target Parameters Table tab is shown in Figure 100.
Figure 101. SNMPv3 Target Parameters Table Tab (Monitoring)