Allied Telesis AT-S63 - Manual (Page 131)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 131
Temporary (Memory)
Displays the events stored in temporary memory. This selection
stores approximately 4,000 events. If the switch has been running
for some time without a reset or power cycle, select Temporary.
This is the default.
Permanent (NVS)
Displays events stored in nonvolatile memory, which stores no
more than 2,000 events. If the switch was recently reset or power
cycled and you want to view the events that occurred prior to the
reset, select Permanent.
4. To display events of a selected severity, in the Severity Selections
list, select one or more of the following severity types:
D - Debug
Debug messages provide detailed high-volume information that
is intended only for technical support personnel.
E - Error
Only error messages are displayed. Error messages indicate that
the switch operation is severely impaired.
W - Warning
Only warning messages are displayed. These messages indicate
that an issue may require manager attention.
I - Information
Only informational messages are displayed. Informational
messages display useful information that you can ignore during
normal operation.
ALL
All messages of any type are displayed.
To select more than one severity, use <Ctrl> click.
5. To choose the chronological order of events in the display, for
Display Order, click one of the following:
Chronological
Displays the events in the order from the oldest event to the most
recent event. This is the default.
Reverse Chronological
Displays the events in from the most recent event to the oldest
event.
6. To select the format of the event log, for Mode, click one of the
following: