Allied Telesis AT-S63 - Manual (Page 36)

Chapter 2: Starting a Web Browser Management Session
36 Section I: Basic Features
Saving Your Parameter Changes
When you make a change to a switch parameter, the change is, in most
cases, immediately activated as soon as you click the Apply button on
the page. However, a change to a switch parameter is initially saved only
to temporary memory. It is lost the next time you reset or power cycle
the unit. To permanently save a change, you must click the Save
Changes button. This button is located on the General tab.
To locate the button, from the home page click Configuration. The
General tab is displayed. The Save Changes button is at the bottom of the
page. If the button is not displayed, there are no changes for the switch
to save.
Figure 4. Save Changes Button in the General Tab (Configuration)
Save Changes Button