Allied Telesis AT-S63 - Manual (Page 74)

Chapter 6: Port Parameters
74 Section I: Basic Features
Configuring Port Parameters
To configure the parameter settings of a port on the switch, perform the
following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Layer 1 option.
3. Select the Port Settings tab.
The Port Settings tab is shown in Figure 18.
Figure 18. Port Settings Tab (Configuration)
4. Click the port in the graphical switch image that you want to
configure. The selected port turns white. You can select more than
one port at a time to configure. (To deselect a port, click it again.)
5. Click Modify. To configure all the ports, click Modify All.
Note
If you select Modify All, you cannot configure the port name or set
the speed and duplex mode. The speed and duplex mode are set to
autonegotiate.