Configuring ssh – Allied Telesis AT-S63 User Manual
Page 318
Chapter 21: Secure Shell (SSH)
318
Section IV: Security
Configuring SSH
To display the MAC address security level of a port, perform the
following procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 6 on page 44.
2. From the Configuration menu, select the Security option.
The Security page is displayed with the 802.1x Port Access tab
displayed by default, as shown in Figure 129 on page 334.
3. Select the Secure Shell tab.
The Secure Shell tab is shown in Figure 121.
Figure 121. Secure Shell Tab (Configuration)
4. Adjust the following parameters as necessary:
Key ID
Enter a host key ID. The default is Not Defined. Enter a value that
you configured in the encryption menus using the AT-S63 menus
interface.
Server Key ID
Enter a server key ID. The default is Not Defined. Enter a value that
you configured in the encryption menus using the AT-S63 menus
interface.