Enabling or disabling gvrp on a port – Allied Telesis AT-S63 User Manual
Page 288
Chapter 18: GARP VLAN Registration Protocol (GVRP)
288
Section III: VLANs
Enabling or Disabling GVRP on a Port
To enable or disable GVRP on a port, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Layer 2option.
The Layer 2 page is displayed with the MAC Address tab displayed
by default, as shown in Figure 23 on page 90.
3. Select the GVRP tab.
The GVRP tab is shown in Figure 106 on page 286.
4. In the GVRP Port Configuration section, click the ports that you want
to configure.
5. Click Modify.
The GVRP Port Configuration page is shown in Figure 107.
Figure 107. GVRP Port Configuration Page
6. Click Normal to have the port propagate GVRP information, or None
to prevent processing GVRP information and transmitting PDUs.
7. Click Apply to save the change, or Cancel to cancel.