Allied Telesis AT-S63 - Manual (Page 91)

AT-S63 Management Software Web Browser Interface User’s Guide
Section I: Basic Features 91
3. To add a static unicast address, in the View/Add Unicast MAC
Addresses section, click Add. To add a static multicast address, in the
View/Add Multicast MAC Addresses section, click Add.
The Add MAC Address page is shown in Figure 24.
Figure 24. Add MAC Address Page
4. Adjust the following parameters as necessary.
MAC Address
The new static unicast or multicast MAC address.
Port Number
The number of the port on the switch where you want to assign
the static address. If you are adding a static unicast address, you
can enter only one port.
If you are entering a static multicast address, you must specify the
port when the multicast application is located as well as the ports
where the host nodes are connected. Assigning the address only
to the port where the multicast application is located results in the
failure of the multicast packets to be properly forwarded to the
host nodes. You can specify the ports individually (e.g., 1,4,5), as a
range (e.g., 11-14) or both (e.g., 15-17,22,24).
VLAN ID
The VLAN ID where the port is a member.
5. Click Apply.
6. Repeat this procedure to add other static addresses to the switch.
7. To permanently save the change, return to the General tab on the
System page and click Save Changes.
For more information about what the Save Changes button does,
refer to ”Saving Your Parameter Changes” on page 36.