Allied Telesis AT-S63 - Manual (Page 341)

AT-S63 Management Software Web Browser Interface User’s Guide
Section IV: Security 341
Auth Period
Specifies the period of time in seconds that the supplicant waits
for a reply from the authenticator after sending an EAP-Response
frame. The range is 1 to 60 seconds. The default is 30 seconds.
Held Period
Specifies the amount of time in seconds the supplicant is to
refrain from retrying to re-contact the authenticator in the event
the end user provides an invalid username and/or password. After
the time period has expired, the supplicant can attempt to log on
again. The range is 0 to 65,535 seconds. The default value is 60
seconds.
Max Start
Specifies the maximum number of times the supplicant sends
EAPOL-Start frames before assuming that there is no
authenticator present. The range is 1 to 10. The default is 3.
Start Period
Specifies the time period in seconds between successive attempts
by the supplicant to establish contact with an authenticator when
there is no reply. The range is 1 to 60. The default is 30.
User Name
Specifies the username for the switch port. The port sends the
name to the authentication server for verification when the port
logs on to the network. The username can be from be from 1 to 16
alphanumeric characters (A to Z, a to z, 1 to 9). Do not use spaces
or special characters, such as asterisks or exclamation points. The
username is case sensitive.
User Password
Specifies the password for the switch port. The port sends the
password to the authentication server for verification when the
port logs on to the network. The password can be from 1 to 16
alphanumeric characters (A to Z, a to z, 1 to 9). Do not use spaces
or special characters, such as asterisks or exclamation points. The
password is case sensitive.
6. Click Apply.
7. To permanently save the change, return to the General tab on the
System page and click Save Changes.
For more information about what the Save Changes button does,
refer to ”Saving Your Parameter Changes” on page 36.