Configuring supplicant port parameters – Allied Telesis AT-S63 User Manual
Page 340
Chapter 23: 802.1x Port-based Network Access Control
340
Section IV: Security
Configuring Supplicant Port Parameters
To configure supplicant port parameters, perform the following
procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Security option.
The Security page is displayed with the 802.1x Port Access tab
selected by default, as shown in Figure 129 on page 334.
3. Click the supplicant port that you want to configure. You can select
more that one supplicant port at a time. The selected port turns white.
Note
A port must already be designated as a supplicant before you can
configure its settings. For instructions on how to set the role of a
port, refer to ”Setting Port Roles” on page 334.
4. Click Settings.
The Supplicant Parameters page is shown in Figure 131.
Figure 132. Supplicant Parameters Page
5. Adjust the following parameters as needed: