Allied Telesis AT-S63 - Manual (Page 249)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 249
6. To save your changes, return to the General tab and click Save
Changes.
Modifying a
Target
Parameters
Table Entry
To modify an entry in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure Target
Parameters Table and then click Configure at the bottom of the tab.
The SNMPv3 Target Parameters Table tab is shown in Figure 88 on
page 245.
4. Click the button next to the Target Parameters Table entry that you
want to change, and then click Modify.
The Modify SNMPv3 Target Parameter page is shown in Figure 90
on page 249.
Figure 90. Modify SNMPv3 Target Parameter Page
Note
Enter a value for the Message Processing Model field only if you
select SNMPv1 or SNMPv2c as the Security Model. If you select the
SNMPv3 protocol as the Security Model, then the switch
automatically assigns the Message Processing Model to SNMPv3.