Allied Telesis AT-S63 - Manual (Page 278)

Chapter 17: Virtual LANs
278 Section III: VLANs
Deleting a VLAN
To delete a port-based or tagged VLAN from the switch, perform the
following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected
by default, as shown in Figure 23 on page 90.
3. Select the VLAN tab.
The VLAN tab is shown in Figure 103 on page 272.
4. Click the button next to the name of the VLAN you want to delete.
(You cannot delete the Default_VLAN.)
5. Click Remove.
A confirmation prompt is displayed.
6. Click OK to delete the VLAN or Cancel to cancel the procedure:
If you click OK, the VLAN is deleted from the switch. The untagged
ports in the VLAN are returned to the Default_VLAN as untagged
ports.
7. To permanently save the change, return to the General tab on the
System page and click Save Changes.
For more information about what the Save Changes button does,
refer to ”Saving Your Parameter Changes” on page 36.