Allied Telesis AT-S63 - Manual (Page 240)

Chapter 16: SNMPv3
240 Section II: Advanced Features
You can enter a name of up to 32 alphnumeric characters.
6. In the IP Address field, enter the IP address of the host.
Use the following format for an IP address:
XXX.XXX.XXX.XXX
7. In the UDP Port Number field, enter a UDP port number.
You can enter a UDP port in the range of 0 to 65,535. The default
UDP port is 162.
8. In the Timeout field, enter a timeout value in milliseconds.
When an Inform message is generated, it requires a response from
the switch. The timeout value determines how long the switch
considers the Inform message an active message. This parameter
applies to Inform messages only. The range is from 0 to
2,147,483,647 milliseconds. The default value is 1500 milliseconds.
9. In the Retries field, enter the number of times the switch retries, or
resends, an Inform message.
When an Inform message is generated, it requires a response from
the switch. This parameter determines how many times the switch
resends an Inform message. The Retries parameter applies to
Inform messages only. The range is 0 to 255 retries. The default is
3 retries.
10. In the Tag List field, enter a list of tags that you configured in a
SNMPv3 Notify Table with the Notify Tag parameter.
See ”Creating a Notify Table Entry” on page 233. Enter a Tag List of
up to 256 alphanumeric characters. Use a space to separate
entries, for example:
hwengtag swengtag testengtag
11. In the Target Parameters field, enter a Target Parameters name.
This name can consist of up to 32 alphnumeric characters. The
value configured here must match the value configured with the
Target Parameters Name parameter in the SNMPv3 Target
Parameters Table.
12. In the Storage Type field, enter one of the following storage types for
this table entry: