Allied Telesis AT-S63 - Manual (Page 224)

Chapter 16: SNMPv3
224 Section II: Advanced Features
13. To save your changes, return to the General tab and click Save
Changes.
Deleting an
Access Table
Entry
To delete an entry in the SNMPv3 Access Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure Access
Table and then click Configure at the bottom of the tab.
The SNMPv3 Access Table tab is shown in Figure 76 on page 221.
4. Click Next or Previous to display the Access Table entry that you want
to delete.
5. Click Remove.
A warning message is displayed. Click OK to remove the Access
Table entry.
6. To save your changes, return to the General tab and click Save
Changes.
Modifying an
Access Table
Entry
To modify an entry in the SNMPv3 Access Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure Access
Table and then click Configure at the bottom of the tab.
The SNMPv3 Access Table tab is shown in Figure 76 on page 221.
4. Click Next or Previous to display the Access Table entry that you want
to change.
5. Click Modify.