Allied Telesis AT-S63 - Manual (Page 184)

Chapter 15: MSTP
184 Section II: Advanced Features
Configuring MSTP
This section contains the following procedures:
❑ ”Configuring MSTP Parameters” on page 184
❑ ”Configuring the CIST Priority” on page 187
❑ ”Creating, Deleting, or Modifying MSTI IDs” on page 189
❑ ”Adding, Removing, or Modifying VLAN Associations to MSTIs” on
page 192
❑ ”Configuring MSTP Port Parameters” on page 195
Note
MSTP must be selected as the active spanning tree protocol on the
switch before you can configure it. For instructions on selecting the
active spanning tree, refer to ”Enabling MSTP” on page 182.
Note
When MSTP is enabled, the GVRP tab is not shown on the
Configuration or Monitoring Layer 2 page.
Configuring
MSTP
Parameters
To configure MSTP parameters, perform the following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected
by default, as shown in Figure 23 on page 90.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 51 on page 164.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 62.