Allied Telesis AT-S63 - Manual (Page 77)

AT-S63 Management Software Web Browser Interface User’s Guide
Section I: Basic Features 77
redundant port automatically transitions to Auto-Negotiate to
match the speed of the primary uplink port and you cannot
configure the MDI/MDIX crossover parameter.
Note
1000 Mbps speed is only available when you set the port to
autonegotiate. You cannot set this manually.
If you select all ports, the Speed and Duplex setting displays “Not
Configurable,” because all ports are set to autonegotiate.
Broadcast Filter
Use this parameter to limit the number of ingress broadcast
packets the port receives. The possible settings are:
Enabled - The port does not receive any broadcast packets.
Disabled - The port receives broadcast packets. This is the default
setting.
For further information about filters, refer to Chapter 6, “Port
Parameters,” in the AT-S63 Management Software Menus Interface
User’s Guide.
Unknown Unicast Filter
Use this parameter to limit the number of ingress unknown
unicast packets the port receives. The possible settings are:
Enabled - The port does not receive any unknown unicast packets.
Disabled - The port receives unknown unicast packets. This is the
default setting.
Unknown Multicast Filter
Use this parameter to limit the number of ingress unknown
multicast packets the port receives. The possible settings are:
Enabled - The port does not receive any unknown multicast
packets.
Disabled - The port receives unknown multicast packets. This is
the default setting.
Flow Control
Sets flow control on a port. This option only applies to ports
operating in full-duplex mode. A switch port uses back pressure to
control the flow of ingress packets. The switch sends a special
pause packet to stop the end node from sending frames. The