Allied Telesis AT-S63 - Manual (Page 335)

AT-S63 Management Software Web Browser Interface User’s Guide
Section IV: Security 335
3. To set a port’s role, click on the port. The selected port turns white.
You can select more than one port at a time.
4. Click Port Role.
The Port Role Configuration page is shown in Figure 130.
Figure 130. Port Role Configuration Page
5. Select the desired role for the port. The possible settings are:
None
The port is not to participate in port-based access control. This is
the default setting.
Authenticator
The port is to function as an authenticator. This is the appropriate
setting if the port is connected to a supplicant.
Supplicant
The port is to function as an supplicant. This is the appropriate
setting if the port is connected to an authenticator. A port can
have only one port role at a time.
6. Click Apply.
To enable or disable port-based access control, go to ”Enabling or
Disabling 802.1x Port-based Network Access Control” on page
336. Then, to configure authenticator port settings, go to
”Configuring Authenticator Port Parameters” on page 337. To
configure supplicant port settings, go to ”Configuring Supplicant
Port Parameters” on page 340.